Havd betyder det....

Har du onboard LAN?

nej der ikke er helle ikke onboard lyd..

“I recently (in mid MAY) bought an AMPTRON PM-8420A board with CYRIX PR-200 mhz (2.8v) chip installed by AMPTRON. I installed two 32 mb 10ns dimm chips for a total of 64mb. The board seems to have problems with WINDOWS NT SERVER 4.0. After leaving the computer running for a couple of hours the system \"blue-screen\'s\" (crashes) with one of two different errors - page fault in non-paged area, or IRQ not less than or Equal. I have never had a problem like this with my other motherboard and INTEL Pentium 120. What advice can you give me? I\'m thinking of posting this problem on the internet mentioning the AMPTRON board, but I wouldn\'t want to give you any bad publicity if you don\'t deserve it. Any suggestions?”

The problem here is that the SDRAM is probably being affected by the higher \"above industry standard\" speeds of 75MHz. SDRAM has a very fine memory timing pattern that can cause hang ups when pushed to the limit. Try dropping the speed of the processor to PR166 (66MHz X 2) and see if it continues to give you problems. This way you can isolate the problem and see if it is due to the processor.

http://www.amptron.com/html/faqs.html

Hvis du har en Award bios, så prøv at gå ind under PNP/PCI Configuration Setup.
Se efter om der står CPU to PCI Write buffer, sæt den til Disabled.
PCI Dynamic Bursting Disable
PCI Master 0 WS Write Disable
PCI Delay Transaction Disable

Det har hjulpet mig!