Antal BIB ved opstart

http://www.bioscentral.com/ => BIOS Beep Codes

det er da forskelligt for hvert bundkort.. Er det ikk'??
Det står næsten altid i din manual. Ellers står det inde på producentens hjemmeside.

Jeg fandt den selv, her er den, hvis andre har brug for listen.

1 beep: DRAM refresh failure. The memory refresh circuitry on the motherboard is faulty.
2 beeps: Parity Circuit failure. A parity error was detected in the base memory (first 64k Block) of the system.
3 beeps: Base 64K RAM failure. A memory failure occurred within the first 64k of memory.
4 beeps: System Timer failure. Timer #1 on the system board has failed to function properly.
5 beeps: Processor failure. The CPU on the system board has generated an error.
6 beeps: Keyboard Controller 8042-Gate A20 error. The keyboard controller (8042) contains the gate A20 switch which allows the computer to operate in virtual mode. This error message means that the BIOS is not able to switch the CPU into protected mode.
7 beeps: Virtual Mode (processor) Exception error. The CPU on the motherboard has generated an Interrupt Failure exception interrupt.
8 beeps: Display Memory R/W Test failure. The system video adapter is either missing or Read/Write Error its memory is faulty. This is not a fatal error.
9 beeps: ROM-BIOS Checksum failure. The ROM checksum value does not match the value encoded in the BIOS. This is good indication that the BIOS ROMs went bad.
10 beeps: CMOS Shutdown Register. The shutdown register for the CMOS memory Read/Write Error has failed.
11 beeps: Cache Error / External Cache Bad. The external cache is faulty.


andre fejl:
2 short beeps: POST failed. This is caused by a failure of one of the hardware testing procedures.
1 long & 2 short beeps: Video failure. This is caused by one of two possible hardware faults. 1) Video BIOS ROM failure, checksum error encountered. 2) The video adapter installed has a horizontal retrace failure.
1 long & 3 short beeps: Video failure. This is caused by one of three possible hardware problems. 1) The video DAC has failed. 2) the monitor detection process has failed. 3) The video RAM has failed.
1 long beep: POST successful. This indicates that all hardware tests were completed without encountering errors.

har du et LINK til denne??

Nej jeg fandt den her på Eksperten

oki.. men var det det fejl at jeg fik pointz?

Nej for det er en god side du henviser til

Oki.. Takker For Pointz!

jeg bruger selv www.bioscentral.com, når jeg skal bruge beep codes..

Her er et par gode link til emnet:
POST Power On Selftest  Bios start up problemer  http://www.ontrack.com/hardwareinfo/startup.asp#C3
POST Hvad betyder de forskellige bib 
http://www.aquanet.co.il/vip/ben-gur/errbeeps.html
http://www.spurdens.freeserve.co.uk/pc/postbeeps.htm