Prestige 642

Fra manualen til din router:
------------------------
Internet Access 3-15
3.15 Multiple Servers behind SUA
If you wish, you can make inside servers for different services, e.g., web or FTP, visible to the outside users,
even though SUA makes your whole inside network appear as a single machine to the outside world. A
service is identified by the port number, e.g., web service is on port 80 and FTP on port 21.
As an example, if you have a web server at 192.168.1.2 and an FTP server 192.168.1.3, then you need to
specify for port 80 (web) the server at IP address 192.168.1.2 and for port 21 (FTP) another at IP address
192.168.1.3.
Prestige 642R Series ADSL Router
Please note that a server can support more than one service, e.g., a server can provide both FTP and DNS
service, while another provides only web service. Also, since you need to specify the IP address of a server
in the Prestige, a server must have a fixed IP address and not be a DHCP client whose IP address potentially
changes each time it is powered on.
In addition to the servers for specific services, SUA supports a default server. A service request that does not
have a server explicitly designated for it is forwarded to the default server. If the default server is not
defined, the service request is simply discarded.
To make a server visible to the outside world, specify the port number of the service and the inside IP address
of the server in Menu 15 – SUA Server Setup.
----------------------------
Så det ser ud til at du bare skal definere en default server, så vil alt blive ruted til den. (det kan selvfølgelig være din egen pc)

Har jeg prøvet.. men der er stadigvæk et eller andet galt, for jeg ka ik sende filer over msn. der er stadig et eller andet der blokere, og jeg har åbnet portene til det.. men der er en filter menu i routerens config , som også har noget med porte at gøre, men jeg fatter bare ik hvordan man indstiller det.. men ellers tak for svaret

Det tror jeg ikke du kan få til at virke. Jeg husker et andet spørgsmål, hvor konklusionen blev at når man har en privat ipaddresse (og det har du fordi din router giver dig en ipaddresse) så kan man ikke sende og modtage filer, fordi afsender addressen netop er privat og derfor "non routable" på internetttet.
MS skriver også lidt om det på denne side:
http://www.microsoft.com/WindowsXP/pro/techinfo/deployment/natfw/natfwissues.asp#natfwissues

Her er udplukket:


File Transfer
File Transfer (FT) requires that the initiating station pass its address to the FT peer in the session exchange through the server. Because of this, the first issue listed under application sharing and whiteboard applies:


The address provided by the initiating station might be an internal address that is translated by a NAT device. This is an invalid address for the peer to use for the TCP connection.
The TCP connection for file transfer, which could be initiated by the external party, presents an additional issue.

Both incoming and outgoing TCP connections use the range of ports from 6891 to 6900. This allows up to 10 simultaneous file transfers per sender. These ports must be open on any firewall between the peers. If you open only port 6891, users will only be able to do one file transfer at a time.

Parantes bemærket, kan jeg nævne at jeg kan heller ikke sende filer gennem min router !! Så jeg tror ikke du får det til at virke.

Og her er en større diskussion om præcis det samme. (uden en løsning)
http://www.dslreports.com/forum/remark,1685941~root=equip,9~mode=flat

hmm mange tak for hjælpen.. konklusion af dette må være at Routere stinker !!!!

Ja, præcis i dette tilfælde gør de.
Takker for point. :-)