ekstern hd, usb, linux

fat32 er faktisk det eneste du kan bruge hvor du kan skrive/læse via begge styresystemer. så det er glimrende..

har du prøvet at mounte den manuelt ?

mount /dev/sda /mnt/usb

måske

mount -t vfat /dev/sda /mnt/usb

Kan være den hedder sda1 istedet for sda. Men der må du nok lige prøve dig lidt frem..

eller også se hvad den hedder med

dmesg

Jeg får beskeden:
"mount: monteringspunkt /mnt/usb eksisterer ikke"

dmesg giver dette resultat(jeg har klippet lidt i det):
----------------------------------------------------
hda: Maxtor 6Y120P0, ATA DISK drive
blk: queue c03be900, I/O limit 4095Mb (mask 0xffffffff)
hdc: JLMS XJ-HD166S, ATAPI CD/DVD-ROM drive
hdd: CD-RW IDE5224, ATAPI CD/DVD-ROM drive
ide0 at 0x1f0-0x1f7,0x3f6 on irq 14
ide1 at 0x170-0x177,0x376 on irq 15
hda: host protected area => 1
hda: 240121728 sectors (122942 MB) w/7936KiB Cache, CHS=14946/255/63, UDMA(133)
ide-floppy driver 0.99.newide
Partition check:
hda: hda1 hda2 hda3 hda4 < hda5 >
ide-floppy driver 0.99.newide
md: md driver 0.90.0 MAX_MD_DEVS=256, MD_SB_DISKS=27
md: Autodetecting RAID arrays.
md: autorun ...
md: ... autorun DONE.
NET4: Linux TCP/IP 1.0 for NET4.0
IP Protocols: ICMP, UDP, TCP, IGMP
IP: routing cache hash table of 8192 buckets, 64Kbytes
TCP: Hash tables configured (established 262144 bind 65536)
Linux IP multicast router 0.06 plus PIM-SM
NET4: Unix domain sockets 1.0/SMP for Linux NET4.0.
RAMDISK: Compressed image found at block 0
Freeing initrd memory: 144k freed
VFS: Mounted root (ext2 filesystem).
Journalled Block Device driver loaded
kjournald starting.  Commit interval 5 seconds
EXT3-fs: mounted filesystem with ordered data mode.
Freeing unused kernel memory: 128k freed
usb.c: registered new driver usbdevfs
usb.c: registered new driver hub
usb-uhci.c: $Revision: 1.275 $ time 17:26:20 Mar 13 2003
usb-uhci.c: High bandwidth mode enabled
usb-uhci.c: USB UHCI at I/O 0xe000, IRQ 11
usb-uhci.c: Detected 2 ports
usb.c: new USB bus registered, assigned bus number 1
hub.c: USB hub found
hub.c: 2 ports detected
usb-uhci.c: USB UHCI at I/O 0xe400, IRQ 11
usb-uhci.c: Detected 2 ports
usb.c: new USB bus registered, assigned bus number 2
hub.c: USB hub found
hub.c: 2 ports detected
usb-uhci.c: v1.275:USB Universal Host Controller Interface driver
usb.c: registered new driver hiddev
usb.c: registered new driver hid
hid-core.c: v1.8.1 Andreas Gal, Vojtech Pavlik <vojtech@suse.cz>
hid-core.c: USB HID support drivers
mice: PS/2 mouse device common for all mice
hub.c: new USB device 00:11.2-1, assigned address 2
EXT3 FS 2.4-0.9.19, 19 August 2002 on ide0(3,5), internal journal
hub.c: USB hub found
hub.c: 3 ports detected
Adding Swap: 1566328k swap-space (priority -1)
hub.c: new USB device 00:11.2-1.2, assigned address 3
input0: USB HID v1.10 Mouse [B16_b_02 USB-PS/2 Optical Mouse] on usb1:3.0
hub.c: new USB device 00:11.2-1.3, assigned address 4
usb.c: USB device 4 (vend/prod 0x4b4/0x6830) is not claimed by any active driver
.
SCSI subsystem driver Revision: 1.00
Initializing USB Mass Storage driver...
usb.c: registered new driver usb-storage
usb-uhci.c: interrupt, status 2, frame# 1629
scsi0 : SCSI emulation for USB Mass Storage devices
  Vendor: Maxtor 6  Model: Y060L0            Rev:  0 0
  Type:  Direct-Access                      ANSI SCSI revision: 02
WARNING: USB Mass Storage data integrity not assured
USB Mass Storage device found at 4
USB Mass Storage support registered.
kjournald starting.  Commit interval 5 seconds
EXT3 FS 2.4-0.9.19, 19 August 2002 on ide0(3,2), internal journal
EXT3-fs: mounted filesystem with ordered data mode.
hdc: ATAPI 48X DVD-ROM drive, 512kB Cache, UDMA(33)
Uniform CD-ROM driver Revision: 3.12
scsi1 : SCSI host adapter emulation for IDE ATAPI devices
  Vendor: CDWRITER  Model: IDE5224          Rev: 001H
  Type:  CD-ROM                            ANSI SCSI revision: 02
parport0: PC-style at 0x378 (0x778) [PCSPP,TRISTATE]
parport0: irq 7 detected
Attached scsi CD-ROM sr0 at scsi1, channel 0, id 0, lun 0
sr0: scsi3-mmc drive: 52x/52x writer cd/rw xa/form2 cdda tray
ip_tables: (C) 2000-2002 Netfilter core team
8139too Fast Ethernet driver 0.9.26
divert: allocating divert_blk for eth0
eth0: RealTek RTL8139 Fast Ethernet at 0xf097a000, 00:30:4f:15:ec:36, IRQ 12
eth0:  Identified 8139 chip type 'RTL-8139C'
eth0: Setting 100mbps full-duplex based on auto-negotiated partner ability 45e1.
parport0: PC-style at 0x378 (0x778) [PCSPP,TRISTATE]
parport0: irq 7 detected
lp0: using parport0 (polling).
lp0: console ready
Creative EMU10K1 PCI Audio Driver, version 0.20, 17:28:18 Mar 13 2003
emu10k1: EMU10K1 rev 10 model 0x8067 found, IO at 0xd000-0xd01f, IRQ 5
ac97_codec: AC97 Audio codec, id: EMC40 (Unknown)
emu10k1: SBLive! 5.1 card detected
Via 686a/8233/8235 audio driver 1.9.1-ac2
via82cxxx: Six channel audio available
PCI: Setting latency timer of device 00:11.5 to 64
ac97_codec: AC97 Audio codec, id: ALG48 (Unknown)
via82cxxx: Codec rate locked at 48Khz
via82cxxx: board #1 at 0xE800, IRQ 12
usb.c: USB disconnect on device 00:11.2-1.3 address 4
hub.c: new USB device 00:11.2-1.3, assigned address 5
WARNING: USB Mass Storage data integrity not assured
USB Mass Storage device found at 5
usb.c: USB disconnect on device 00:11.2-1.3 address 5
hub.c: new USB device 00:11.2-1.3, assigned address 6
WARNING: USB Mass Storage data integrity not assured
USB Mass Storage device found at 6
usb.c: USB disconnect on device 00:11.2-1.3 address 6
Attached scsi disk sda at scsi0, channel 0, id 0, lun 0
sda: Spinning up disk.................................<6>hub.c: new USB device 0                                                                            0:11.2-1.3, assigned address 7
.<7>WARNING: USB Mass Storage data integrity not assured
USB Mass Storage device found at 7
.ready
SCSI device sda: 120103200 512-byte hdwr sectors (61493 MB)
sda: sda1
usb-uhci.c: interrupt, status 3, frame# 1784

------------------------------------------
Hvad kan jeg gøre ved det?
palau

ehm mount pointet skal jo eksitere før du kan gøre det..

opret mappen først med

mkdir /mnt/usb

"mount: monteringspunkt /mnt/usb eksisterer ikke"

Du kunne jo prøve at oprette den folder med "mkdir /mnt/usb"

...

husk at linux er case sensitive... :)

USB Mass Storage device found at 7
.ready
SCSI device sda: 120103200 512-byte hdwr sectors (61493 MB)
sda: sda1

----> device hedder dermed /dev/sda1



mkdir /mnt/usb && mount -t vfat /dev/sda1 /mnt/usb

Du skal være root for at benytte mount kommandoen.

Folderen er nu oprettet

# mount -t vfat /dev/sda1 /mnt/usb

Giver:

mount: forkert filsystemtype, forkert tilvalg, ugyldig superblok på /dev/sda1,
      eller for mange monterede filsystemer

Det kan betyde 2 ting:
Enten er din eksterne harddisk ikke fat32
Ellers mangler du en fat32 driver. Prøv "modprobe vfat" og gentag så ovenstående kommando. Hvis det stadig ikke virker, så skal du have en ny kernel.

Har du vfat i kernen ? Nu kender jeg ikke lige SÅ meget til RH men du kan evt prøve at loade vfat modulet først

modprobe vfat.

Ok, det lyder alvorligt.

jeg må desværre smutte nu, men et tilbage i aften

Så virker det. strych9 havde ret. Min hd var NTFS. Jeg havde ellers formateret den via kommandoprompten i den tro at fat32 var default. Men da hd'en var større end 32gb, havde computeren alligevel valgt NTFS. SNYDT!!. Nå men nu er der i hvert fald hul igennem.

Mange tak for hjælpen til jer begge.

-->strych9, hvis du vil have points, så smid et svar.

palau

ok
husk at undgå at skrive til en ntfs disk fra linux. Der er ikke ordentlig support for det, og meget kan gå galt.

Jeg har formateret til fat32, (denne gang er jeg helt sikker :-) ), så det skulle funke nu.