Hvor sættes defautl gateway på en novell 5.0

Gå ind og ret det manuelt, jeg kan ikke lige huske hvor man gør det henne, men i autoexcec.ncf. kan du i linien hvor dit netkort er tilføje GATE= som der står herunder :-)

BIND IP DLKPCI_1_EII MASK=255.255.255.0 GATE=192.168.1.1 ADDRESS=192.168.10.1

Den korrekte måde at dætte default gateway/route på en Netware 5 server er at gøre det via IPCONFIG.

En komplet beskrivelse har du her:

For NetWare 4.x/5.x servers it is recommended that the Default Route be configured in the INETCFG utility:

  1- LOAD INETCFG
  2- Select> PROTOCOLS
  3- Select> TCPIP
  4- Select> Static Routing
  5- Select> Enabled
  6- Select> Static Routing Table: <enter>
  7- <insert> to bring up the Static Route Configuration
  8- Select> \"Route to Network or Host\" and <enter> to Bring up options
  9- Select> \"Default Route\" <enter>
10- Press down arrow key to \"Next Hop Router on Route\"
11- Enter ip address of the router.

12- Press the <Escape> key until you have exited INETCFG.
    NOTE: \"Save\" or \"Update\" as directed.

13- Enter the console command \"reinitialize system\" to push the new default route onto the routing table.

    NOTES: In the event that the new default route does not appear in the routing table, i.e., TCPCON does not show it, then you may need to down the server and bring it back up. If the server cannot be \"downed\", then you will need to unload TCPIP, and then perform a \"reinitialize system.\" Many times, there are processes that are depending or running on TCPIP and therefore, TCPIP cannot be unloaded until these process are stopped or unloaded. The new default route will be placed in the routing table each time the server is started.

        Once the default route is set up, you can verify it under the TCPCON utility. Load TCPCON and select IP Routing Table. Press <Enter> on Proceed. You should see an entry that looks like this:

        Destination Next Hop Type Cost Interface
        default 206.100.100.254 remote 1 <#>

NOTE: If the default route is not showing. then you can put a dynamic default route in the IP ROUTING TABLE. Remember that any routes placed in TCPCON are dynamically added and will be lost when the server is downed. This suggestion is primarily for those who cannot down the server until after hours but need the default rout to take effect immediately. The procedures are as follows:

1. LOAD TCPCON
    Select ---> IP ROUTING TABLE
        Select ---> PROCEED: <ENTER> WHEN DONE
            <INSERT> to bring up a new IP ROUTE INFORMATION table.

    By default the destination will be default and mask of 0.0.0.0. Make the Next Hop you default router\'s IP address. This next part is critical. Change the Interface number to the same number as the NIC card on the router\'s segment. If this is not done, the route will not be added. The route will take effect immediately. Entering any route in TCPCON is not a solution, but rather TCPCON should be used as a diagnostic tool.

NanoQ

ja, det var der, TAK