RHEL4 - Bonding 2 x bcm5700 1 GB = 200Mbit
Hej AlleJeg har en hp dl 360 g4 server kørende rhel 4.
Jeg vil gerne køre bonding på netkortene men kan ikke få den rigtige hastighed. Nogen der kan hjælpe
eth0: Using PCI INTX interrupt
bonding: Warning: failed to get speed/duplex from eth0, speed forced to 100Mbps.
bonding: bond0: enslaving eth0 as an active interface with an up link.
eth1: Using PCI INTX interrupt
bonding: Warning: failed to get speed/duplex from eth1, speed forced to 100Mbps.
bonding: bond0: enslaving eth1 as an active interface with an up link.
bcm5700: eth0 NIC Link is UP, 1000 Mbps full duplex
bcm5700: eth1 NIC Link is UP, 1000 Mbps full duplex
ethtool eth0
Settings for eth0:
Supported ports: [ TP ]
Supported link modes: 10baseT/Half 10baseT/Full
100baseT/Half 100baseT/Full
1000baseT/Half 1000baseT/Full
Supports auto-negotiation: Yes
Advertised link modes: 10baseT/Half 10baseT/Full
100baseT/Half 100baseT/Full
1000baseT/Half 1000baseT/Full
Advertised auto-negotiation: Yes
Speed: 1000Mb/s
Duplex: Full
Port: Twisted Pair
PHYAD: 0
Transceiver: internal
Auto-negotiation: on
Supports Wake-on: g
Wake-on: d
Link detected: yes
ethtool eth1
Settings for eth1:
Supported ports: [ TP ]
Supported link modes: 10baseT/Half 10baseT/Full
100baseT/Half 100baseT/Full
1000baseT/Half 1000baseT/Full
Supports auto-negotiation: Yes
Advertised link modes: 10baseT/Half 10baseT/Full
100baseT/Half 100baseT/Full
1000baseT/Half 1000baseT/Full
Advertised auto-negotiation: Yes
Speed: 1000Mb/s
Duplex: Full
Port: Twisted Pair
PHYAD: 0
Transceiver: internal
Auto-negotiation: on
Supports Wake-on: g
Wake-on: d
Link detected: yes
