Cisco 677 og messenger

Nedenstående er fra, Håber dette kan hjælpe
http://support.microsoft.com/default.aspx?scid=KB;EN-US;q278887&

To enable voice communications, make sure that outgoing TCP connections from port 6901 are enabled. Also enable UDP packets where either the source or the destination port is 6901.

To enable file transfers, enable both incoming and outgoing TCP connections to the 6891-6900 range of TCP ports. This allows each sender to perform up to 10 simultaneous file transfers. Note that if only TCP port 6891 is open, users are only able to perform one file transfer at a time.

To enable messaging, enable outgoing TCP connections to TCP port 1863.

NOTE: On the Connections tab in the MSN Messenger Options dialog box, make sure that the I use a Proxy Server check box is not selected.

ok, men hvordan skal det sættes op???

Hvad skal jeg skrive i telnet????

Du skal skrive:

set nat entry add 10.0.0.2 6901 212.242.XXX.XXX 6901 tcp
set nat entry add 10.0.0.2 6901 212.242.XXX.XXX 6901 udp
set nat entry add 10.0.0.2 6891-6900 212.242.XXX.XXX 6891-6900 tcp
set nat entry add 10.0.0.2 1863 212.242.XXX.XXX 1863 tcp
write
reboot

Erstat 212.242.XXX.XXX med din WAN-IP og erstat evt. 10.0.0.2 med en anden intern IP hvis du ikke har 10.0.0.2 men måske 10.0.0.3 i stedet(?).