Login Cisco 1921

https://supportforums.cisco.com/thread/2192051

Det hjelper ikke at trykke ctrl+Break, jeg får kun denne smøre.


System Bootstrap, Version 15.0(1r)M16, RELEASE SOFTWARE (fc1)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 2012 by cisco Systems, Inc.

Total memory size = 512 MB
CISCO1921/K9 platform with 524288 Kbytes of main memory
Main memory is configured to 64 bit mode with ECC disabled


Readonly ROMMON initialized
program load complete, entry point: 0x80903000, size: 0x4c4a0
program load complete, entry point: 0x80903000, size: 0x4c4a0


IOS Image Load Test
___________________
Digitally Signed Release Software
program load complete, entry point: 0x81000000, size: 0x41a4608
Self decompressing the image : ################################################################################################################################################################################################################################################################################################################################################################################################### [OK]

Smart Init is enabled
smart init is sizing iomem
                TYPE      MEMORY_REQ
          HWIC Slot 0      0x00200000
    Onboard devices &
        buffer pools      0x01E8F000
-----------------------------------------------
              TOTAL:      0x0208F000

Rounded IOMEM up to: 36Mb.
Using 7 percent iomem. [36Mb/512Mb]

              Restricted Rights Legend

Use, duplication, or disclosure by the Government is
subject to restrictions as set forth in subparagraph
(c) of the Commercial Computer Software - Restricted
Rights clause at FAR sec. 52.227-19 and subparagraph
(c) (1) (ii) of the Rights in Technical Data and Computer
Software clause at DFARS sec. 252.227-7013.

          cisco Systems, Inc.
          170 West Tasman Drive
          San Jose, California 95134-1706



Cisco IOS Software, C1900 Software (C1900-UNIVERSALK9-M), Version 15.2(4)M3, RELEASE SOFTWARE (fc2)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2013 by Cisco Systems, Inc.
Compiled Tue 26-Feb-13 02:11 by prod_rel_team


This product contains cryptographic features and is subject to United
States and local country laws governing import, export, transfer and
use. Delivery of Cisco cryptographic products does not imply
third-party authority to import, export, distribute or use encryption.
Importers, exporters, distributors and users are responsible for
compliance with U.S. and local country laws. By using this product you
agree to comply with applicable laws and regulations. If you are unable
to comply with U.S. and local laws, return this product immediately.

A summary of U.S. laws governing Cisco cryptographic products may be found at:
http://www.cisco.com/wwl/export/crypto/tool/stqrg.html

If you require further assistance please contact us by sending email to
export@cisco.com.

Installed image archive
Cisco CISCO1921/K9 (revision 1.0) with 487424K/36864K bytes of memory.
Processor board ID FCZ1715C27A
6 Gigabit Ethernet interfaces
1 terminal line
1 Virtual Private Network (VPN) Module
DRAM configuration is 64 bits wide with parity disabled.
255K bytes of non-volatile configuration memory.
249840K bytes of USB Flash usbflash0 (Read/Write)



Press RETURN to get started!

:54:40.755: %VPN_HW-6-INFO_LOC: Crypto engine: onboard 0  State changed to: Initialized
*Jul  9 11:54:40.759: %VPN_HW-6-INFO_LOC: Crypto engine: onboard 0  State changed to: Enabled
*Jul  9 11:54:41.587: %LINK-3-UPDOWN: Interface GigabitEthernet0/0, changed state to up
*Jul  9 11:54:41.587: %LINK-3-UPDOWN: Interface GigabitEthernet0/1, changed state to down
*Jul  9 11:54:42.487: %LINEPROTO-5-UPDOWN: Line protocol on Interface Vlan1, changed state to down
*Jul  9 11:54:42.587: %LINEPROTO-5-UPDOWN: Li

User Access Verification

Username: ne protocol on Interface GigabitEthernet0/0, changed state to up
*Jul  9 11:54:42.587: %LINEPROTO-5-UPDOWN: Line protocol on Interface GigabitEthernet0/1, changed state to down
*Jul  9 11:54:46.695: %USBFLASH-5-CHANGE: usbflash0 has been inserted!
*Jul  9 11:54:49.215: %SYS-5-CONFIG_I: Configured from memory by console
*Jul  9 11:54:51.131: %LINK-5-CHANGED: Interface Embedded-Service-Engine0/0, changed state to administratively down
*Jul  9 11:54:51.135: %LINK-5-CHANGED: Interface GigabitEthernet0/1, changed state to administratively down
*Jul  9 11:54:52.135: %LINEPROTO-5-UPDOWN: Line protocol on Interface Embedded-Service-Engine0/0, changed state to down
*Jul  9 11:54:52.543: %LINEPROTO-5-UPDOWN: Line protocol on Interface GigabitEthernet0/0/0, changed state to down
*Jul  9 11:54:52.543: %LINEPROTO-5-UPDOWN: Line protocol on Interface GigabitEthernet0/0/1, changed state to down
*Jul  9 11:54:52.543: %LINEPROTO-5-UPDOWN: Line protocol on Interface GigabitEthernet0/0/2, changed state to down
*Jul  9 11:54:52.543: %LINEPROTO-5-UPDOWN: Line protocol on Interface GigabitEthernet0/0/3, changed state to down
*Jul  9 11:54:52.547: %SYS-5-RESTART: System restarted --
Cisco IOS Software, C1900 Software (C1900-UNIVERSALK9-M), Version 15.2(4)M3, RELEASE SOFTWARE (fc2)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2013 by Cisco Systems, Inc.
Compiled Tue 26-Feb-13 02:11 by prod_rel_team
*Jul  9 11:54:52.591: %SNMP-5-COLDSTART: SNMP agent on host yourname is undergoing a cold start
*Jul  9 11:54:53.215: %SSH-5-ENABLED: SSH 1.99 has been enabled
*Jul  9 11:54:53.227: %CRYPTO-6-ISAKMP_ON_OFF: ISAKMP is OFF
*Jul  9 11:54:53.227: %CRYPTO-6-GDOI_ON_OFF: GDOI is OFF
*Jul  9 11:54:53.227: %CRYPTO-6-ISAKMP_ON_OFF: ISAKMP is OFF
*Jul  9 11:54:53.227: %CRYPTO-6-GDOI_ON_OFF: GDOI is OFF
% Username:  timeout expired!
Username:

har du evt mulighed for en show run ??
eller show start up

Der er TeraTerm jeg bruger og den skal habe Alt+b istedet fot Ctrl+Break
Så nu virkede det, chalde send et svar, det løste problemet.

/ Finn

Lukketid