konfigurering af netgear router

Hej

Jeg har en netgear router som jeg skal have sat op til at kunne håndtere wake on lan.

Jeg har fundet en opskrift her: http://forum1.netgear.com/showthread.php?t=191&highlight=wake+on+lan

Som lyder:
"
Since most Netgear routers won't allow you to forward to the subnet's broadcast address when it ends in 255....what you need to do is change the subnet of the router so it changes the broadcast address.

Now in that section you will see something that says 'LAN TCP/IP Setup' and just below it it says 'IP Subnet Mask'. What you need to do is change the IP Subnet Mask to 255.255.255.128.

Now when you create a Wake-on-Lan port forwarding rule, use 192.168.0.127 as the IP address. This will cause the WOL packet to be broad-casted to the subnet and this should cause your computer to boot up."

Kort sagt jeg skal:
1) Ændre min subnet mask til: 255.255.255.128
2) Hvad med DHCP skal den så sættes til at køre fra 192.168.0.1 til f.eks. 192.168.0.50
3) Der skal laves en port forward på den port der bruges som sendes til 192.168.0.127 (da den så sendes til alle ip adresser inden for 192.168.0.X ikke?

Er det rigtig forstået eller er jeg gal på den?

Mvh
Jesper